What are the use conditions of the reducer?

1. The reducer is allowed to be used in continuous working occasions, the working environment is non-corrosive, and it is allowed to run in both forward and reverse directions at the same time; the working environment temperature is -40-45℃, if it is lower than 0℃, lubricate before starting The oil should be preheated to above 0°C.
2. The rated speed of the input shaft is 1500 rpm. When the input power is greater than 18.5 kW, it is recommended to use a 960 rpm 6-pole motor for supporting use; the output shaft cannot be subjected to large axial and radial forces. Other measures must be taken when there is a large axial force and radial force; the peripheral speed of the gear drive is not more than 20 m/s.
3. The working position of the reducer is horizontal. The larger horizontal inclination angle during installation is generally less than 15°. When it exceeds 15°, other measures should be taken to ensure adequate lubrication and prevent oil leakage.
It is a good phenomenon that the use of reducer has certain restrictions, otherwise it will easily lead to accidents. In order to ensure that the equipment can work normally for a long time, strict inspection, maintenance and maintenance are required on a regular basis, which can not only avoid the existence of hidden dangers that endanger the personal safety of the operators, but also effectively extend the service life of the equipment. Work is necessary.